![]() However, if this iPhone 6 Plus has been in a case, it would have been questionable whether it would have fit. The gray silicone grips on the insides of the clamps are visible in the photo above as well.Ībove, a closeup of the top clamp jaw’s gray silicone grip.Īn iPhone 6 Plus will fit into the clamp mechanism, but it is a tight fit, and I had to pry the jaws apart a bit to get the iPhone to fit, but not excessively so. When in use, the clamp’s jaws are folded outward, as shown above. The jaws can be folded down, as shown above, when not in use. The clamp consists of two pivoting jaws with soft silicone grips that hold your phone securely. The fill light has three levels that can be used, the brightest of which is shown illuminated above.Ībove you can see the clamping mechanism that holds your phone. The fill light can spin 360 degrees for the ultimate in fine-tuning. The light level can be fine-tuned by rotating its barrel shape from fully open, as seen above… The Fill Light has a build-in diffuser, to soften the light’s intensity and reduce the “harshness” or glare from it. Still, it’s not all that difficult to do.Īnother interesting feature of the Mpow Bluetooth Selfie Stick is the fill light, which sits atop the clamp mechanism, as seen in the image above. I found this a bit strange I’m not sure why the power to the Fill Light couldn’t have been directly incorporated into the body of the Selfie Stick. In order for the fill light to work, the micro-USB cable must be plugged into the micro-USB port on the side of the bracket that holds the light. Instead, it provides power to the fill light. This cable is NOT for charging the device. The Selfie Stick has a small, coiled Micro-USB cable attached to its side. How the heck was I going to figure out how to use this thing? The reality is that it is a fairly easy-to-use device, which you will see below. In fact, I was a bit intimidated by it at first. The pouch will accommodate the Selfie Stick itself, with room to spare for the USB charging cable.Īfter removing the Selfie Stick from its pouch, the first thing I notice about it was that it certainly appeared to be feature-rich. The pouch is made of a quality mate al, and feels like it may be fairly water-resistant. Let’s dive in, starting with the included drawstring pouch, which the Selfie Stick had been placed in for shipping. Inside, the Selfie Stick was inside its storage pouch, which was enclosed in a bubble-wrap bag for protection. The MPow Bluetooth Selfie Stick arrived in some fairly standard packaging, which consisted of a white cardboard box with a few photographs showing the product. Holder accommodates phones 1.8-3.3 inches wide.Telescoping length is 7.3 inches at shortest position and 34.3 inches at longest position.1500 mAh battery for 72 hours of fill light time, 30 hours of Bluetooth time or 3 years standby with full charging time of 2.5 hours.Built-in Bluetooth remote shutter control.Below are listed the technical specs of the MPow Bluetooth Selfie Stick: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |